LocostUSA.com
http://www.locostusa.com/forums/

Food for thought Mid engine sports racer with Mazda
http://www.locostusa.com/forums/viewtopic.php?f=18&t=683
Page 2 of 2

Author:  John Se [ May 16, 2011, 10:54 pm ]
Post subject:  back alive

I have this body roughed in on the chassis with clecos, I have some sidepods to build an a little front and rear structure, I hope to keep it going this summer, new pics soon.

As usual its very easy to spend alot of time designing and not enough doing the hard work of the build, right now I am procrsatinating on laying on my back drilling and removing 200 rivets.

It's the work when I have to be on the ground that slows me up! Much more painful than it used to be, se la vie,

After that I need to fab up a layout jig I can bolt to the chassi to square up the new body and front and rear structure. Then get the body positively located to real structure

Author:  horizenjob [ May 17, 2011, 12:12 am ]
Post subject:  Re: Food for thought Mid engine sports racer with Mazda

:cheers:

Author:  John Se [ January 1, 2012, 12:09 pm ]
Post subject:  Re: Food for thought Mid engine sports racer with Mazda

body work in position while car is on alignment jig I made, Body was for a slightly longer wheelbase car, so I plan on cutting about 2 inches from the side pods. Decisions need to be made about cooling set up.

Author:  a.moore [ January 3, 2012, 6:23 pm ]
Post subject:  Re: Food for thought Mid engine sports racer with Mazda

Who makes the body?

Author:  kikiturbo [ January 4, 2012, 4:56 am ]
Post subject:  Re: Food for thought Mid engine sports racer with Mazda

from this angle looks like a Radical...

Author:  John Se [ January 6, 2012, 12:54 am ]
Post subject:  Re: Food for thought Mid engine sports racer with Mazda

Body work is from Hurley Racing Products, design was done by Clark Lincoln retired from the GM design Studios. Have to figure out cooling now and finish up some substructure to hold up the body.

http://www.hurleyracingproducts.com/cus ... llery.html, body for mine is the second two on his page.

Here is the chassis underneath

http://www.fototime.com/inv/DBB818EFA49630A

having to choose side inlet ducting:
Attachment:
good radiator style.jpg


or top/front ducting ala Storh
Attachment:
139105601_100_0396.jpg


crossle lsr top duct design-2.JPG[/attachment]

Author:  John Se [ March 14, 2013, 1:06 pm ]
Post subject:  Re: Food for thought Mid engine sports racer with Mazda

Some Progress on the rebody, actually alot of progress

Author:  Off Road SHO [ March 14, 2013, 2:13 pm ]
Post subject:  Re: Food for thought Mid engine sports racer with Mazda

Looking good. Are those side air inlets for cooling radiators and engine?

Tom

Author:  John Se [ March 15, 2013, 11:58 am ]
Post subject:  Re: Food for thought Mid engine sports racer with Mazda

Yes, side inlets for Water and possibly oil radiators, cut out but not open all the way in the pic.

Page 2 of 2 All times are UTC - 5 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/