LocostUSA.com

Learning how to build Lotus Seven replicas...together!
It is currently September 25, 2018, 6:01 am

All times are UTC - 5 hours [ DST ]




Post new topic Reply to topic  [ 2 posts ] 
Author Message
PostPosted: September 23, 2017, 9:47 am 
Offline

Joined: February 12, 2011, 4:19 am
Posts: 13
Well I ended up with a couple buckets that were just not going to work. They were 22" wide on the sides with the extra bolsters and rolled edge supports.. and my cockpit width is at 18" and 18.5".

The $500 pair on up for the narrow seating options did not look appealing.

So , peeled back the seat covering, a few minutes of Jig saw work and we are all set.

I fit the 18" or so width, so I don't need much extra alongside the chassis rails.

GH


Attachments:
Optimized-IMG_20170914_124041.jpg
Optimized-IMG_20170914_124041.jpg [ 866.47 KiB | Viewed 692 times ]
Optimized-IMG_20170914_115431.jpg
Optimized-IMG_20170914_115431.jpg [ 486.49 KiB | Viewed 692 times ]
Optimized-IMG_20170914_115032.jpg
Optimized-IMG_20170914_115032.jpg [ 805.87 KiB | Viewed 692 times ]
Top
 Profile  
Reply with quote  
PostPosted: September 24, 2017, 8:16 pm 
Offline

Joined: August 27, 2017, 6:20 pm
Posts: 81
What frame are you using to get the 18' and 18.5" cockpit? I have a couple race seats that are 18" at their widest.


Top
 Profile  
Reply with quote  
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 5 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
POWERED_BY