rx7locost wrote:
Ewhen, I can only imagine what you went
And, if you haven't heard it lately, Thank you for your service!
Thanks
Well, there were about many millions of
people from different countries of Europe
So on positive note I learned to speak few
more languages.
Here more important think to follow
When You use shrinker to form fenders
it is important to design a radius of desired
shape (ie.clearance between tire, length)
on a piece of cardboard (or other surface)
Shrink both sides of the bent, two three
times each and check if radius corresponds
to design. Overshrink is corrected with a tap
of a hammer in affected area.
Wish I could make explicit video of it
it's so darn easy, if I ordinary Ukrainian
peasant could do it, so everybody else
can do it too.
Please Chuch, send us a pic of hand-made
fenders
Cheers
ewhen