Attachment:
20210905_121218_compress28.jpg
This sheet came off of a Sprinter Van that had a window installed, figured it was too nice to just toss.
Attachment:
20210905_141239_compress23.jpg
Attachment:
20210905_171210_compress96.jpg
Attachment:
20210906_154636_compress46.jpg
Played around with the English wheel forming the dash, still lots to do on that front.
Attachment:
20210905_111659_compress81.jpg
Attachment:
20210905_110821_compress34.jpg
Attachment:
20210905_111630_compress81.jpg
The previous engine mounts were not up to the task so I Cobbled these together using Mini cooper LCA bushings, 1uz wristpins as a dowel, and exhaust tubing. There will be an 1/8" or 3/16" flange on either side to the floor when I go bankrupt myself at the metal supply store again.
Attachment:
20210906_173333_compress31.jpg
Attachment:
20210906_173326_compress96.jpg
Work continues on the Sill panels.
Attachment:
rear quarter overlay super8_compress62.jpg
A trace of the buck in its current form illustrates a higher window line for the doors along with a side vent. Id like to run a flat floor front to rear and airflow will need a path to flow other then down, hood vents may also be necessary.
Attachment:
front super8 overlay_compress36.jpg
Of course the buck also needs to be reworked from some problems with how the front and rear end look, good to catch them now though. Above is a trace with the front grille shortened (yet it still looks large)