I didn't get nearly as much done as I had hoped.
The plywood sheet worked OK for mock-up, but it wasn't working well enough to build a real car.
I have a work bench that is almost big enough to build on, but it is buried under 4 years of grinder dust and misc accumulations. Half a day was spent cleaning off the table.
Finally got the table cleared an my subrails on the table. Table is about two feet too short for the body to fit. No problem. I built an outrigger to support the point of the boat tail.
Time to start building body structure out of 1x1. Square tubing may be great for building boxes, but it sucks for the complex shapes in this car. Got one hoop done in the rear body and tried to make a hoop for the cowl. Succeded in making lots of scrap out of 1x1 . On to plan B.
Make the cowl from 16 gauge flat sheet. This was my first real project with the horrible freight shrinker/stretcher. I think it went well. I think it would have been easier if I made my angle 1x1 instead of 1.5x1.5 (oh well).
Here are the pics.