My fault, I momentarily lost track of the thread. I have a better sequence of photos somewhere but can't seem to locate them, I have added a few photos I did find. It should be enough to give the idea. I basically used 16 ga sheet steel to make a couple of plates that I bent to follow the contour of the seat back. I took some tube with me to Pick A Part to find some headrests that fit the tube best, in my case the rear seat out of an Infinity if I recall right. The rear headrests are also better condition than most front ones, so look there first. I used button head bolts, the photos doesn't show the fender washers I used. Hope this helps
Al
You do not have the required permissions to view the files attached to this post.
_________________ Super Seven 3.4
|