LocostUSA.com

Learning how to build Lotus Seven replicas...together!
It is currently September 26, 2020, 7:17 am

All times are UTC - 5 hours [ DST ]




Post new topic Reply to topic  [ 1 post ] 
Author Message
PostPosted: August 26, 2020, 9:18 pm 
Offline

Joined: August 26, 2020, 8:22 pm
Posts: 1
Working on the wire harness for my Locost Miata based project. I removed wires from the ECU connector. I made changes I needed and started to connect them back using the electrical schematics. Then I realized that I have one extra black wire not shown on the schematic.
I traced it back and it is a ground wire but where should it go into the ECU connector?
Can any owner of 1989 or 1990 manual Miata wire harness take a picture of the longer ECU connector from both sides?
Or if you have better schematic please let me know where the extra black wire goes.

Thank you.

This is what the schematic shows.


Attachments:
ECU Connector missing black wire.jpg
ECU Connector missing black wire.jpg [ 728.76 KiB | Viewed 1352 times ]
Extra ECU ground.jpg
Extra ECU ground.jpg [ 38.81 KiB | Viewed 1352 times ]
Top
 Profile  
Reply with quote  
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC - 5 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 11 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
POWERED_BY