LocostUSA.com

The sealed electrical header/bulkhead/wall receptacles look good. I've been looking at Digikey's AMP plastic round connectors too (around page 382), which are reasonably priced compared to the mil spec stuff. These would make a nice firewall junction for wiring versus a rubber boot or a poor fitting grommet.

My breadtruck uses the contoura switches. I have one position that does nothing. I'm going to use it as a theft deterent by replacing it with a 3 way contoura with a monetary to one side, then run the starter relay wire through the switch in series with the momentary position of the key switch. By the time you purchase all the pieces, the contoura costs $7-9 each depending on the config but they look great, are modular, and have plenty of flexibility. I've seen them used a lot on high end motorcoaches.

_________________
Miata UBJ: ES-2074R('70s maz pickup)
Ford IFS viewtopic.php?f=5&t=13225&p=134742
Simple Spring select viewtopic.php?f=5&t=11815
LxWxHt
360LA 442E: 134.5x46x15
Lotus7:115x39x7.25
Tiger Avon:114x40x13.3-12.6
Champion/Book:114x42x11
Gibbs/Haynes:122x42x14
VoDou:113x44x14
McSorley 442:122x46x14
Collins 241:127x46x12

$10.89
http://www.amazon.com/dp/B000Y84KRM/ref ... B000Y84KRM

Water Resistant Contura Switch in action
http://www.4x4review.com/Features/Featu ... fault.aspx

The switches can be found by searching for "Water Resistant Contura Switch" or "Water Resistant Contura Switch Panels" carried by most marine supply stores or online.

Elegant solution

_________________
I'll keep an eye out for you!

To err is human...
I am more human than most.