Didn't make it to the pick n pull to look for axles. I'll give that a go at a later date.
Today I went to work on two must get done projects. The rear wing stays and the side pod sheetmetal.
The wing stays were pretty easy. I picked a random height and layback for the rear stays that would give me a pleasing to the eye height for the wing and cut 1" OD 1/8 wall tube to length.
I cut a couple of 1/8 x 1 strips and drilled to bolt to the wing. Then lightly tacked those to the stays at a 20 degree layback.
A bit of fiddling with magnetic weld brackets, clamps, and some creative twisting and holding got the rear stays tacked in place.
then a few measurements and cut some 1/2 x .065 wall tube for the front stays. These got 20 degree bends 3 inches from the end, then more finagling with weld clamps and creative holding to tack them on.
Bolt on the wing, measure measure measure measure some more, then weld.
Attachment:
wing.jpg
Now I can do chin ups from the wing without it moving. I try to move it side to side and I can move the trailer before the wing flexes.
No pics of the side pods today. I did cut the sheet metal and bend. Still have to trim around the fuel fill and fuel pressure regulator to get it all to fit up.