LocostUSA.com

Learning how to build Lotus Seven replicas...together!
It is currently June 21, 2021, 6:45 am

All times are UTC - 5 hours [ DST ]




Post new topic Reply to topic  [ 1 post ] 
Author Message
 Post subject: Using Miata NC knuckles
PostPosted: January 19, 2021, 5:21 pm 
Offline

Joined: January 18, 2021, 1:04 pm
Posts: 6
So I am in the VERY early stages of (presumably) a Vodou build using a Miata NC as a donor. I secured a 2006 on the cheap and would have preferred an NA or NB, but the price was too good to pass up. I have seen a few posts with respect to using the NC front knuckles, but couldn't seem to locate a definitive answer here as to how best to adapt them (if in fact anyone here has). There is a gentleman in Australia that used a combo of Ford Transit and B2200 parts, along with machining the Miata knuckles...but it seemed like there SHOULD be an easier answer. My own private utopia would be an off the shelf screw in ball joint that would fit both the NC knuckle and Kinetic control arms. Wishful thinking? Thank you in advance for any and all advice.

P.S. I am trying to avoid using wheel adapters to get the 5 on 114.3 as much as humanly possible.


Top
 Profile  
Reply with quote  
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC - 5 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 18 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
POWERED_BY